Ableton Live Intro Manuel d'instructions télécharger pdf (Page 334)

CHAPTER 25. USING THE APC40 332

25.10 Customizing the APC40 Controls

You can change the assignment of all of the knobs, faders and buttons on the APC40 by

enabling the Remote switches in the MIDI/Sync Preferences, as described in the section on

manual control surface setup.

Setting Up The APC40

For Custom

Assignments.

Now, by entering Live's MIDI Map Mode, you can override the pre-assigned functions of all

of the APC40's knobs, faders and buttons. The eight Track Control knobs can be assigned

in four banks, which can be switched with the buttons below them. Likewise, the Device

Control knobs can be assigned in eight banks by holding down Shift while pressing one of

the eight buttons below these knobs.

Tip: If you have overridden the APC40's default mappings with manual mappings, you can

easily switch back to the defaults by deactivating the Remote switch of the APC40's input

port. Activating the switch again will re-establish your manual mappings.

25.11 Combination Mode

The APC40 controller becomes even more powerful when combined with additional APC40s

or the Akai Professional APC20.

When you connect more than one APC unit to Ableton Live, the controllers will automatically

work in Combination Mode. You can use up to six total APC20s or APC40s side by side. The

topmost controller selected in your preferences will control tracks 1-8, the second controller

selected will control tracks 9-16, and so on. When an APC40 and an APC20 are connected

at the same time, the APC20's buttons will default to Track Selection, and its faders will

default to volume, allowing swift access to an expanding array of clips and tracks.

1 2 ... 329 330 331 332 333 334 335 336 337 338 339 ... 409 410

Vikinin 04 Jan 2024 | 12:03:19

urenrjrjkvnm

Ableton Live Intro Manuel d'instructions Page 334